Sony clie PEG-SL10 Operating Instructions Manual page 196

Precaut ions
Charging the internal pow er source
To avoid losing data stored on your CLIÉ handheld, do not remove new
batteries during the first 1 hour after inserting them.
Your CLIÉ handheld has a small internal power source to maintain your
data while you switch batteries. This internal power source is charged from
the batteries when you first insert batteries into your CLIÉ handheld or
when you insert new batteries after a long period of not using your CLIÉ
handheld. Charging the internal power source takes about 1 hour. If you
remove the batteries before the internal power source is charged, your CLIÉ
handheld's memory will revert to the factory settings and any data you have
entered will be lost.
If batteries are leaking
• Carefully wipe off any liquid in the battery compartment before inserting
new batteries.
• If battery leakage comes in contact with your skin, wash it off
immediately.
• If battery leakage comes in contact with your eyes, immediately rinse
your eyes thoroughly with water and promptly seek medical attention.
Battery life
• With new alkaline batteries, you can use your CLIÉ handheld for
approximately 20 days*.
* Based on an average of 30 minutes use of PIMs per day, with the backlight off.
• Battery life varies depending on the conditions and environment where
you use your CLIÉ handheld.
• IF THE BATTERY IN YOUR CLIÉ HANDHELD IS FULLY DISCHARGED OR
REM OVED, ALL DATA STORED ON THE SDRAM (M EM ORY) IS LOST. IN
SUCH A CASE, PERFORM ING A HOTSYNC
BATTERIES ARE REPLACED CAN RESTORE BACKED UP INFORM ATION
SAVED ON YOUR COM PUTER (FROM THE LAST HOTSYNC
OPERATION) TO YOUR CLIÉ HANDHELD. FOR DETAILS, SEE "BACKING
UP DATA TO YOUR COM PUTER THROUGH A HOTSYNC
ON PAGE 184.
Chapt er 6
Downloaded from:
Additional information
https://www.usersmanualguide.com/
®
OPERATION ONCE THE
®
OPERATION"
Continued on next page
196