Sony clie PEG-SL10 Operating Instructions Manual page 112

Advanced Hot Sync
3
4
Not e
When performing a local HotSync operation with the USB cable after you make the
HotSync Setup settings for an IR HotSync operation, you should restore the local
HotSync settings. For details, see "To restore the local HotSync settings" on page 113.
Performing an IR HotSync operation
After you prepare your computer and your CLIÉ handheld, and select your
Conduit Setup options, you are ready to perform an IR HotSync operation.
1
2
3
4
Chapt er 3
Downloaded from:
®
operat ions
Click t he Local t ab t o change t he set t ing f or an IR Hot Sync
operat ion as needed.
• Serial Port: Specifies a virtual port for an infrared port. If you are not
sure of the connection port, see the Infrared Monitor in the Windows
Control Panel.
• Speed: Determines the speed at which data is transferred. Try the "As
Fast As Possible" rate first, and adjust downward if you experience
problems.
Tap OK.
Your computer is ready to perform an IR HotSync operation.
Rot at e t he Jog Dial
t he Jog Dial navigat or. Or t ap t he Hot Sync
Applicat ion Launcher screen.
The HotSync dialog box appears.
Tap Local.
Tap t he arrow V beneat h t he
Handheld f rom t he drop-dow n list .
Point t he IR port of your CLIÉ handheld direct ly at t he IR port
of t he receiving comput er.
Tip
For best results, your computer and your CLIÉ handheld should be 4 to 8 inches
(approximately 10 to 20 centimeters) apart, and the path between your CLIÉ
handheld and the computer must be clear of obstacles.
Exchanging and updating data using a HotSync
https://www.usersmanualguide.com/
™
navigat or t o select Hot Sync and press
icon and select IR t o a PC/
® operation
icon on t he
Continued on next page
112