Table of Contents
Advertisement
11.7 My Performance Meter runs permanently
If the Performance Meter runs continuously, even when stationary, the widget is assigned the wrong
sensor. To assign the right sensor there are 2 ways:
unlocking the pages, click performance meter, assigning the sensor speed, locking the pages.
or
On the computer: Connect to the DSS, select the performance meter, assign the sensor speed.
11.8 My shift flash doesn't work
If the external switching flash does not work, there can be several reasons:
Please check whether plausible speed thresholds are stored for the individual LEDs under Setup ->
Shiftlight.
Please check whether the sensor RPM is assigned appropriately under Setup -> 5.3
If both are correct, only the following remains to be checked: When starting the data display, the
switching flash should run once. If this is not the case, the cabling must be checked.
11.9 How do I change my home logo?
It is possible to change the start animation or the start image. The animation consists of 20 images
that are played one after the other. The files with the names logo00.bmp to logo19.bmp are located
in the pic folder.
You have two options for changing, but no matter which one you choose, you have to convert your
desired start animation/video into many small .bmp with a size of 320x240 pixels each or only
provide one image with the appropriate size. If you upload only one image you only have one start
image, if you upload several images, you have an animation in which the images run away one after
the other:
• Manually remove the SD card, delete the 20 files and add the newly created images back to the
folder
• From the upload section in the DSS, press remove all logo*.bmp files from SD to delete all logos and
upload the newly created images with the name logo00.bmp using the choose file button
Figure 88: Buttons in the upload section
Once you have transferred all images to your data display, you must then press the erase flash
button on the data display under Setup -> Sensor Init -> erase flash or in the upload section to delete
the flash memory.
11.10 How to get other logos on the pages
Adding your own images and logos is done via the upload section in the DSS (chapter 9.6).
Before uploading, the images must be scaled to the appropriate size using a suitable program.
Rev 1.0
74
Advertisement
Table of Contents
