Table of Contents
Advertisement
9.3.2.11 can switch
The can switch widget is also already known from Gen1. With this widget you can save yourself a Can
Keypad and use your data display as a keypad instead. Possible functions would be switching on and
off additional devices such as pumps or fans or other hidden functions that you have integrated into
your vehicle. The size as well as the colors of the switches can be freely configured. The figure below
shows a switch. In this case, yellow is inactive and green is active.
Figure 47: Keypad with two switches (yellow inactive, green active) and one multiswitch
If desired, a pop-up inform-window can be activated in the DSS when switching the switches. This
then appears briefly when changing the state of a switch. Switches can be designed as both rasters
and buttons.
The settings for the widget can switch are as with the other widgets also position (x/y coord) and size
(x/y size). Use the function can switch # to enter the number of your switch.
Figure 48: Configuration can switch
In addition, you can configure the colors of the two states (inactive/active) via the color wheel. For
each status you can configure two colors, including a gradient and the color of the frame color.
Rev 1.0
48
Advertisement
Table of Contents
