Splash Screen; Start Page; Shiftlight; Dim Sensivity - CAN CHECKED MFD28 Gen2 Manual

Hide thumbs Also See for MFD28 Gen2:

Table of Contents

5.6 Splash Screen

The splash screen is the start image/animation of your data display. In this menu you can set whether

and for how long the splash screen should be displayed when your data display is switched on. By

tapping the number, you can switch between off and a time of one to ten seconds.

Under Start Page you can set on which page your display should be after starting. Here you have the

choice between sides one to ten or last used. With this option, your display starts on the side that

was active when the data display was switched off. Switching between the different options is

analogous to switching the splash screen by clicking on it.

In the submenu Shiftlight you can configure the behavior of your external shift flash. Here you can

set the color and the activation speed threshold for each of the eight switching flash LEDs by tapping

them.

Furthermore, you can set the speed threshold (RPM flash), at which all eight LEDs start flashing.

Other menu items are the global brightness of the LEDs (brightness) and the direction of the gradient

(left2right or right2left).

Under this submenu you can adjust the amount of dimming of your display via the essential function

Dim Display5.3

ATTENTION: At 100%, the display is almost unreadable.

In the submenu Pages you will find a tab for predefined widgets packs. If you have stored them on

your SD card, you can select and activate them here.

For each page on your data display, you'll also find two sliders here.

Figure 12: Pages

The left slider locks or unlocks ("editable") the pages for editing. By default, editing is locked.

The right slider enables ("enabled") or hidden pages. With this function, for example, your display

can only have three pages (page 4-10 hidden) and jumps back to the first page after the third page.

Rev 1.0

Table of Contents

Mfd32 gen2