Table of Contents
Advertisement
Figure 74: Can Switches
Furthermore, you can send up to four Custom Can Frames from your data display to the Can bus.
The frames can be activated individually (Activate).
Figure 75: Can frame
To do this, the number of messages in the frame, the Base ID (Message Id 0x), the transmission rate
(Transmit rate) as well as the Endiness (Endian) and the data type (Data Type) must be specified. The
frame can then be filled with sensors, switches or fixed values. By clicking on write to display, the
changes are reflected in the display.
Any settings you make here are at your own risk. So be very careful with the messages that are sent
here.
9.5.8 User tables
The User Table can be used to combine two sensors into a common output. In the example below, a
value between 0 and 100 is generated from the speed and accelerator pedal sensors, depending on
the condition. This value can be used, for example, to control the actuation of a boost pressure
control valve (N75).
Another conceivable application would be the control of a water-methanol injection (WMI) via the
sensors IAT (intake air temperature) and boost (boost pressure).
Via the DSS, the resolution can be set in 1 to 0.001 steps. The size of the User Table is set via the +
and buttons next to the table. The sensors are assigned by clicking on the axis label (all sensors
available in the TRI/TRX file can be selected).
Values can be entered by clicking on individual cells. In addition to the manual entry via the
keyboard, the mathematical functions can also be added and subtracted as well as interpolated if
several cells are selected.
Rev 1.0
65
Advertisement
Table of Contents
