Table of Contents
Advertisement
Rack-Mounting OS6450 Switches
OS6450-RM-19L Kit - Mounting Instructions
A single chassis can be mounted into a standard 19-inch rack as shown in the figure below.
1
Attach rack mount brackets to both sides of the front of the chassis.The long and short bracket can be
mounted on either side of the chassis.
2
Align the holes in the flanges with the rack holes and insert rack mount screws (not provided) through
the bottom hole of each flange and then the top of each flange. Tighten both screws until they are secure
When rack mounting, a clear-
ance of 0.875 inches is recom-
mended above the chassis.
page 3-10
Attach Rack Mount Brackets
No minimum clearance is required below the chassis
assembly. However, be sure that the bottom of the chassis
is not in direct contact with any equipment below.
Rack-mounting Single Chassis
OmniSwitch 6450 Series Hardware Users Guide
Mounting OmniSwitch 6450 Series Switches
November 2011
Advertisement
Table of Contents
