Os6450-Tray-19 Kit - Mounting Instructions - Alcatel-Lucent OmniSwitch 6450 Series Hardware User's Manual

Mounting OmniSwitch 6450 Series Switches

OS6450-TRAY-19 Kit - Mounting Instructions

Either one or two chassis can be mounted into a standard 19-inch rack using the chassis mounting tray as
shown below:
1
Align the holes in the integrated chassis mounting tray flanges with the rack holes and insert rack
mount screws (not provided) through the bottom hole of each flange and then the top of each flange.
Tighten both screws until they are secure.
2
Place a chassis on the tray aligning the holes on front and back sides of the chassis with the holes in the
chassis mounting tray. Insert and tighten all screws until they are secure
Note. If you are installing two chassis side-by-side in the tray, be sure to install any required center brack-
ets between the two chassis. Refer to your switch's Hardware User Guide for additional information.
OmniSwitch 6450 Series Hardware Users Guide
Attach Chassis Mounting Tray to Rack
Secure Chassis to Tray
November 2011
Rack-Mounting OS6450 Switches
page 3-11