Installing The Remote Annex 5393/Pri; Preparing For Hardware Installation; Setting The Backplane Ethernet Segment - Bay Networks 5393 Hardware Installation Manual

Installing the Remote Annex 5393/PRI

This section describes how to install the Remote Annex 5393/PRI in
a System 5000 Hub. Installing the Remote Annex 5393/PRI involves
seating the backplane connectors to the Model 5000 Hub backplane
and verifying the installation.

Preparing for Hardware Installation

This section explains how to prepare the Remote Annex for
installation in the chassis.
System 5000 equipment uses electronic components that are
sensitive to static electricity. Static discharge from your
clothing or other fixtures around you can damage these
components. You should take all possible precautions to
prevent static discharge damage when working with printed
circuit boards. If possible, place all printed circuit boards on an
antistatic mat until you are ready to install them. If you do not
have an antistatic mat, wear a discharge leash to free yourself
of static before touching any of the printed circuit boards, or
free yourself of static by touching the metal of the chassis before
handling a printed circuit card.

Setting the Backplane Ethernet Segment

Figure 2-1 shows the locations of the configuration jumper and DIP
switch (on the Main Logic Module) that you must set to select an
Ethernet segment. They are:
Ethernet segment bank selector (J6)
Ethernet segment selection DIP switch (S1)
Remote Annex 5393/PRI Hardware Installation Guide
Chapter 2 Installing the Remote Annex 5393/PRI
2-3