Correcting Remote Annex Parameters; Table 4-5. Errors From Last Open Request - Bay Networks 5393 Hardware Installation Manual

Table 4-5. Errors from Last Open Request

Error Description
ARP errors Address Resolution Protocol (ARP) errors indicate
that the Remote Annex is configured to boot from a
specified host, but the host would not transmit its
Ethernet address to the Remote Annex. Possibly, the
Remote Annex configuration includes the wrong IP
encapsulation.
ERPC layer See
errors
Aborts rx'd The host's BFS transmitted an abort in response to the
Remote Annex's Open Request. This often means that
the requested file does not exist on that server. Run
erpcd –D on the host to obtain more information.

Correcting Remote Annex Parameters

The following parameters must accurately reflect both the Remote
Annex and the network environment in which it operates.
Verify the Remote Annex's IP address using the addr command. If
your network configuration does not support the factory defaults,
verify the following parameters using the addr command:
The broadcast address.
The subnet mask.
The load/dump gateway address (which must be specified
if the preferred load server host is located on another
network or subnet).
Remote Annex 5393/PRI Hardware Installation Guide
Chapter 4
Table 4-3.
Troubleshooting Procedures
4-11