Figure C-4. Locating And Setting Dip Switch S1 - Bay Networks 5393 Hardware Installation Manual

4 Lift the modem card straight out of its connector, making sure not to
damage any pins.
5 Referring to Table
corresponds to the location of the modem card you removed.
6 Locate the S1 DIP switch section and set it to the ON position (see
Figure C-4).
.
Figure C-4 Locating and Setting DIP Switch S1
Remote Annex 5393/PRI Hardware Installation Guide
Appendix C
C-1, identify the S1 DIP switch section that
Front of Unit
ON
ON
1 2 3 4 5 6 7 8
Modem Upgrade Instructions
DIP Switch S1
C-7