Table 4-6. Remote Annex 5393/Pri Dump File Naming Conventions - Bay Networks 5393 Hardware Installation Manual

Chapter 4 Troubleshooting Procedures
4-16 Remote Annex 5393/PRI Hardware Installation Guide
For hosts that limit file names to 14 characters (e.g., System V
hosts), a dump creates two additional directories under
/usr/spool/erpcd/bfs. The name of the first directory is dump; the
second directory uses the Remote Annex's IP network address as its
name. The dump file uses the Remote Annex's IP host address as its
name.
The tftp dump names are user-defined. If a name is not
specified, the Remote Annex uses the bfs convention.
Each dump file contains a complete image of the Remote Annex RAM
memory and hardware state. The amount of space required for a
dump file varies according to the port configuration. The ROM
Monitor config command displays the amount of memory for the
Remote Annex.
Table 4-6 shows sample dump file names. All pathnames are relative
to the file /usr/spool/erpcd/bfs.

Table 4-6. Remote Annex 5393/PRI Dump File Naming Conventions

Remote Annex Network
5393/PRI Address Address
63.0.0.75 63
131.140.23.1 131.140
195.46.2.15 195.46.2
BSD
Filename System V Pathname
dump.63.0.0.75 dump/63/0.0.75
dump.131.140.23.1 dump/131.140/23.1
dump.195.46.2.15 dump/195.46.2/15