Self-Booting The Remote Annex - Bay Networks 5393 Hardware Installation Manual

Chapter 2 Installing the Remote Annex 5393/PRI

Self-booting the Remote Annex

2-30 Remote Annex 5393/PRI Hardware Installation Guide
The Remote Annex comes equipped with Flash memory that already
contains an operational image. You can use this to self-boot the
Remote Annex. You can check your Remote Annex's configuration
by entering the config command at the monitor prompt. The config
command displays the current configuration information and
revision levels.
Anytime you want to return to the monitor prompt, press
-C.
Control
To boot your Remote Annex from Flash memory:
1 On the service port terminal, press
the Slot Selection menu.
2 Press 3.
The Supervisory Module Main Menu is displayed.
3 Press m to select the Module Information menu.
The following prompt is displayed:
Enter slot # (1-14):
4 Enter the slot number of the Remote Annex you want to boot.
The module information and status are displayed and you are
prompted to reset the module, set the module configuration to
default, or return to the previous menu.
5 Press d to select the module configuration default.
The following message is displayed:
Are you sure you want to set module DEFAULT
configuration? (Y/N):
6 Press y.
The Slot Selection menu is displayed.
then -T to display
Enter Control