Bay Networks 5393 Hardware Installation Manual page 74

Chapter 2 Installing the Remote Annex 5393/PRI
2-32 Remote Annex 5393/PRI Hardware Installation Guide
14 Enter the IP address for the Remote Annex.
You are prompted to enter the server subnet mask, preferred load
host, preferred dump host, IP packet encapsulation, and load
broadcast. The defaults are listed after each prompt.
15 Enter the information next to each prompt or press
the default.
16 Enter the sequence command at the monitor prompt.
The following prompt is displayed:
Enter interface sequence [net]::
17 Enter the self command.
The monitor prompt is displayed:
monitor::
18 Boot the Remote Annex by entering the boot oper.63.enet
command at the monitor prompt.
Once the Remote Annex has booted, Monitor Mode is no longer
active.
to select
Enter