Booting From A Windows Nt® Host; Booting From Another Remote Annex 5393/Pri; Installing The Operational Software And Loading The Image - Bay Networks 5393 Hardware Installation Manual

Chapter 2 Installing the Remote Annex 5393/PRI
Installing the Operational Software and Loading the
Image
2-28 Remote Annex 5393/PRI Hardware Installation Guide
Once the Remote Annex is booted, Monitor Mode is no longer
operational. The Remote Annex is up and running , and the following
message is displayed:
Console monitor ready; Press CR to start.
Booting from a Windows NT
To boot the Remote Annex from a Windows NT
Remote Annex Server Tools for Windows NT
Annex Server Tools for Windows NT
procedure call daemon (erpcd) running on a Windows NT
Erpcd responds to all Remote Annex boot and dump requests. Refer
to the Remote Annex Server Tools for Windows NT
additional information.

Booting from Another Remote Annex 5393/PRI

Booting from another Remote Annex 5393/PRI requires you to
configure certain parameters both on the Remote Annex 5393/PRI
you are trying to boot, and on the Remote Annex 5393/PRI you are
trying to boot from. See the Remote Annex Administrator's Guide for
Unix for additional information.
Use this section if you have successfully connected the Remote Annex
to your LAN.
®
Host
®
host, you must have
®
installed. Remote
®
uses the expedited remote
®
User Guide for
®
server.