Booting Using Tftp - Bay Networks 5393 Hardware Installation Manual

Chapter 2 Installing the Remote Annex 5393/PRI
2-26 Remote Annex 5393/PRI Hardware Installation Guide
Requesting boot from 192.9.200.88 via Ethernet...
Booting BFS file using open delay of 8
Booting BFS file from 192.9.200.88
Header received OK. Received data blocks shown as '.'.
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . .. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . .. . . . . . . . . . . ? . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . * . . . . .
. . . . . . . . . . . . . . . . . . . . . . . * . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . ? . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EOF
The download takes between 30 and 60 seconds for a Remote
Annex 5393/PRI booting over the local network. After the
download is complete, the Power, Unit, and Net LEDs remain
on. If these LEDs do not remain on (indicating a problem), see
Chapter 4.
Once the Remote Annex is booted, Monitor Mode is no longer
operational. The Remote Annex is up and running, and the following
message is displayed:
Console monitor ready; Press CR to start

Booting Using TFTP

To set up directories and files, and use TFTP to boot the Remote
Annex, follow these steps:
1 Enter the image command at the monitor prompt.
As prompted, enter the following information:
Appropriate boot image name
Boot directory
Dump filename