Table of Contents
Advertisement
Installing a stand-alone AEM
Unpack and level the AEM column
For proper installation, perform the steps in the following procedures in the
order given.
1
Remove the AEM column from the shipping pallet; follow the unpacking
instructions that come with the packaging material.
2
Remove the front and rear covers from the AEM:
a.
Turn the two locking latches (see Figure 3) clockwise with a
standard screwdriver.
b.
Push the latches toward the center of the cover and pull the cover
towards you while lifting it away from the module.
c.
Set the covers aside until the installation is complete.
WARNING
Risk of equipment damage
Module covers are not hinged; do not let go of the
cover. Lift the cover away from the module and set
it out of your work area.
3
Remove the front and rear grills from the pedestal (see Figure 4). Set
the grills aside until the installation is complete.
4
Inspect all equipment for physical damage; report any to your supplier.
5
Adjust the feet on the pedestal to level the column (turn the leveling foot
clockwise to raise it).
Note 1: You must leave at least 12.7 mm (1/2 in.) between the floor and
the bottom of the pedestal for air flow required by the cooling unit.
Application Equipment Module Installation guide
7
Advertisement
Table of Contents
