Configuring Voip Lines; Enterprise: Common; Solution Integration Guide For Multisite Business Communications Manager Systems; Nn49000-303 01.01 Standard - Nortel BCM200 Integration Manual

Table 25
SIP Settings fields
Field
Fallback to
circuit-switched
Domain Name
Call signaling port
Outgoing Transport
Proxy
Status
Configuring VoIP lines
Voice over IP (VoIP) lines simulate traditional Central Office (CO) lines. VoIP
lines transmit data over an IP network rather than over physical lines.
Configuring VoIP lines
Step
1
2
3
4
5

Solution Integration Guide for Multisite Business Communications Manager Systems

Copyright © 2007, Nortel Networks
.
Refer to Table 25 "SIP Settings fields" (page 61)
Value
Disabled
Enabled-TDM
Enabled-All
<port value>
UDP
TCP
Read Only
Action
Log on to Element Manager.
In the Task Navigation Panel, select the Configuration tab.
Select Telephony > Lines > All Lines.
Highlight the individual line you wish to configure.
Select the Preferences tab.
See Figure 17 "Preferences" (page

Enterprise: Common

NN49000-303 01.01 Standard

Release 4.0, 3.7 29 June 2007
Description
Defines how you want the system to handle calls
that the system fails to send over the VoIP trunk.
Enabled-TDM enables fallback for calls
originating on digital telephones. This is useful
if your IP telephones are connected remotely,
on the public side of the BCM network, because
PSTN fallback is unlikely to result in better quality
of service.
Type the domain name of the SIP network.
If VoIP applications are installed that require
nonstandard call signaling ports, enter the port
number here. Port number 0 means that the
system uses the first available port.
If entered, all SIP calls originate to this address.
This field displays the current status of the
Gatekeeper.
—End—
62).
Configuring VoIP lines 61
for more information.