Accessing The Console Menu; Assigning Ip Parameters Using The Console Menu; Ers 5000 Series Installation - Nortel BayStack 5520-48T-PWR Install Manual

84 Procedures for installation of the switch
Prerequisites
•
Terminal with AC power cord and keyboard.
•
Serial cable with a DB-9 female connector on both ends. The maximum
length for the console port cable is 25 feet (8.3 meters).
Procedure Steps
Step
1
2
3

Accessing the console menu

This procedure describes the steps used to access the console menu.
Procedure Steps
Step
1
2
3
4

Assigning IP parameters using the console menu

This procedure describes the steps used to assign IP parameters using
the console menu.
Procedure Steps
Step
1
Copyright © 2008–2009 Nortel Networks
Action
Connect one end of serial cable to the DB-9 connector on the
terminal.
Connect the other end of the serial cable to the DB-9 connector
on the switch.
Turn the terminal on.
Action
Connect a terminal to the console port of the switch.
Set the terminal protocol on the terminal or terminal emulation
program to VT100 and VT100/ANSI.
Connect to the switch using the terminal or terminal emulation
application.
After the Nortel banner is displayed, press CTRL + Y to display
the main menu. The version of the main menu displayed is
dependent on whether the switch is part of a standalone or
stacked switch configuration.
Action
From the console menu, select IP Configuration/Setup.

ERS 5000 Series Installation

NN47200-300 04.03
13 April 2009
--End--
--End--