Web Ui Access Level Management; Saving The Configuration Changes - Grandstream Networks HT812 Administration Manual

For the initial setup, the Web access is by default enabled when the device is using private IP and disabled when using public
IP, and you cannot access the Web UI of your HT812/HT814 until it's enabled, the following steps will show you how to enable
it via IVR.
1. Power your HT812/HT814 using PSU with the right specifications.
2. Connect your analog phone to phone ports (FXS) of your HT812/HT814.
3. Press *** (press the star key three times) to access the IVR menu and wait until you hear "Enter the menu option ".
4. Press 12, the IVR menu will announce that the web access is disabled, press 9 to enable it.
5. Reboot your HT812/HT814 to apply the new settings.
Please refer to steps below if your HT812/HT814 is connected via WAN port:
1. You may check your HT812/HT814 IP address using the IVR on the connected phone.
Please see Obtain the HT812/HT814 IP address via the connected analogue phone
2. Open the web browser on your computer.
3. Enter the HT812/HT814's IP address in the address bar of the browser.
4. Enter the administrator's password to access the Web Configuration Menu.
Note: The computer must be connected to the same sub-network as the HT812/HT814. This can be easily done by connecting
the computer to the same hub or switch as the HT812/HT814.
Via LAN port
Please refer to steps below if your HT812/HT814 is connected via LAN port:
1. Power your HT812/HT814 using PSU with the right specifications.
2. Connect your computer or switch directly to your HT812/HT814 LAN port.
3. Open the web browser on your computer.
4. Enter the default LAN IP address (192.168.2.1) in the address bar of the browser.
5. Enter the administrator's password to access the Web Configuration Menu.
6. Make sure to reboot your device after changing your settings to apply the new configuration.
Please make sure that your computer has a valid IP address on the range 192.168.2.x so you can access the web GUI of your
HT812/HT814.

Web UI Access Level Management

There are three default passwords for the login page:
User Level
End User Level
Administrator Level
Viewer Level
The password is case sensitive with maximum length of 25 characters. When changing any settings, always submit them by
pressing Update or Apply button on the bottom of the page. After submitting the changes in all the Web GUI pages, if a
reboot is required, the web page will prompt the user to reboot by offering a reboot button on the web page.

Saving the Configuration Changes

Password Web Pages Allowed
123 Only Status and Basic Settings
admin All pages
viewer Only checking. Not allowed to modify content.