Grandstream Networks HT812 Administration Manual page 13

FXS Ports: Configures SIP accounts settings, Off hook Auto-dial.
Status Page Definitions
Status
Shows device ID in hexadecimal format. This is needed by network administrators for troubleshooting. The MAC
address will be used for provisioning and can be found on the label on original box and on the label located on
the bottom panel of the device.
MAC
Note: The device has two MAC addresses, one for the WAN port and one for the LAN port. The MAC address
Address
located on the bottom panel of the device is the MAC address of LAN port. The MAC address of WAN port is
MAC address of LAN port +1.
Example: MAC Address: WAN – "00:0B:82:25:AF:32", LAN – "00:0B:82:25:AF:31".
WAN
IPv4 Displays assigned IPv4 address.
Address
WAN
IPv6 Displays assigned IPv6 address.
Address
VPN
IPv4 Displays assigned OpenVPN IPv4 address.
Address
VPN
IPv6 Displays assigned OpenVPN IPv6 address.
Address
Product
Displays product model info. Default is HT812 or HT814.
Model
Hardwa
re Displays the hardware revision information and the part number.
Version
Program: Specifies Program version. This is the main firmware release number, which is always used for
identifying the software system of the HT812/HT814.
Bootloader: Specifies Boot version.
Softwar
e Core: Specifies Core version.
version
Base: Specifies Base version.
CPE: Specifies CPE version. CPE version is displayed only when HT812/HT814 is connected to an ACS using
TR-069 protocol.
Softwar
Indicates the current software status of the HT (Running or Stopped).
e Status
System
Up Indicates actual system time and uptime since last reboot.
Time
CPU
Indicates CPU load (%)
Load