Table of Contents
Advertisement
60
en | Flying the system
X12-125F-DOLLY:
To store an X12-125F-DOLLY, do the following:
1.
2.
3.
4.
5.
Refer to
–
9.2.4
Landing arrays onto a dolly
Landing the array elements directly onto a dolly makes transportation easier.
Notice!
Dolly stacking limits
X12T-DOLLY accommodates two columns of X1 or X2 loudspeaker systems stacked three high
for transportation. The dolly is designed for a total of six loudspeakers per dolly.
i
X12-128-DOLLY accommodates one column of X12-128 subwoofers stacked two high for
transportation. The dolly is designed for a total of two subwoofers per dolly.
X12-125F-DOLLY accommodates one column of X12-125F subwoofers stacked two high when
both subwoofers are facing forward or three high when in cardioid configuration (two
forward facing and one backward facing) for transportation.
Notice!
Dolly wheel (the 4°) hole:
i
The bottom element to be landed on the dolly base must be pinned in the 4° hole ( ) in the
ANGLE SELECT section. Compress the rear link bars until they contact the angle select pin
and lock by adding a second pin in the EVEN holes of the ANGLE LOCK section.
Ensure the two front link bars are lowered and locked.
X12T-DOLLY:
To land an array onto an X12T-DOLLY, do the following:
2019-07 | 04 | F.01U.310.953
Pin the dolly top rear link bars in the retracted (storage) position.
Pull the ball detent pins at the four corners of the dolly base.
Align the front of the dolly top (short, non-retractable bars) with the front of the dolly
base.
Pick up the dolly top cover with link bars pointing down and set it squarely onto the dolly
base so as to nest the four link bars into the V-blocks on each corner.
Insert an attached dolly ball detent pin into each corner V-block to lock the two parts
together.
Ensure the ball detent pin goes through the rigging bar and the other side of the
transport rail.
Transportation dollies, page 20
Installation manual
X-LINE ADVANCE System Rigging & Transport
Electro-Voice
Advertisement
Table of Contents
