Table of Contents
Advertisement
X-LINE ADVANCE System Rigging & Transport
15. Align the extended link bars with the open V-blocks at the top four corners of the
16. Guide the cardioid steering element onto the previously installed element.
17. Twist and lock the four captive twist lock pins at the top of the previously installed
18. Repeat steps 1-17, to add the third element in the stack.
Refer to
–
–
–
–
–
–
7.1.1
X12T-DOLLY side panels and top cover
Installing the dolly side panels
To install the dolly side panels, do the following:
1.
2.
3.
4.
Installing the dolly top cover
To install the dolly top cover, do the following:
1.
2.
Electro-Voice
The front of the next element is aligned with the rear of the previously installed element.
previously installed element.
element.
All four captive twist lock pins are in the closed position. Ensure the element is secure.
X12T-DOLLY side panels and top cover, page 25
X12-125F-DOLLY top cover, page 26
X12-125F-DOLLY accessories, page 27
Ground stacking, page 33
Storing empty dollies, page 59
Landing arrays onto a dolly, page 60
Guide one dolly side panel into the dolly base between the two locking rails and the side
panel guide (A) with the carpeted side facing the loudspeaker grilles.
Ensure the dolly side panel is aligned between the two locking rails and squared to the
side panel guide with the scribble label at the top.
Secure the bungie cord (B) around the two nearest captive twist-lock pin heads on both
edges of the cover.
Repeat steps 1-2 for the three remaining loudspeakers.
Pull and twist open the two captive twist lock pins by the grille on the top two
loudspeakers.
Ensure the top two captive twist lock pins are open on both loudspeakers on the stack.
Guide the link bars of the dolly top cover into the V-blocks of the loudspeaker rigging.
B
A
Installation manual
Transportation dollies | en
2019-07 | 04 | F.01U.310.953
25
Advertisement
Table of Contents
