X12Pu-Bgk Or X12-125Fpu-Bgk Pull-Up Kits - Electro-Voice X-LINE ADVANCE Series Installation Manual

X-LINE ADVANCE System Rigging & Transport
Figure 9.2: X12TE-GRID - Single
Figure 9.3: X12TE-GRID - Dual
Refer to
–
–
–
9.1.3

X12PU-BGK or X12-125FPU-BGK pull-up kits

X12PU-BGK and X12-125FPU-BGK pull-up kits are used when the compression rigging method
is being used with an array or when extreme down angles beyond the capabilities of the
extended grid are required. This is a way to achieve extreme down angles, such as might be
encountered in a distributed arena system. When using one X12TE-GRID and one X12PU-BGK
or one X12-125F-GRID and one X12-125FPU-BGK in this fashion, the angle between the
suspension lines must never be allowed to exceed 30°. For maximum angles, restrictions and
limitations, consult the line array configuration software and follow all limitations and
restrictions recommended by the software. The instructions in this section refer specifically to
the X12PU-BGK pull-up kit for X1 and X2 loudspeakers, the same procedure applies to the
X12-125FPU-BGK for X12-125F subwoofers, except where noted.
Electro-Voice
With pull-up bar
With pull-up bar
X12-125F-GRID grid, page 53
Rigging structural strength ratings and safety factors , page 69
Rigging inspection and precautions, page 73
OR
Without pull-up bar
OR
Without pull-up bar
Installation manual
Flying the system | en 47
2019-07 | 04 | F.01U.310.953