Table of Contents
Advertisement
X-LINE ADVANCE System Rigging & Transport
Notice!
i
Before flying the array, make sure that all captive twist lock pins are fully engaged in the
rigging (no red showing between the pin knob and the element).
To rig the elements together, do the following:
1.
2.
3.
4.
5.
6.
6.3
Setting rear link angles
This section provides the steps to set rear link angles for the X1/X2 full-range elements and
the X12-125F flying subwoofer.
The rear link angle is selected by choosing corresponding holes in the white ANGLE SELECT
sections of the rear rigging on each side as determined by the Electro-Voice line array
configuration software. Unless the rigging is locked into a rigid configuration by secondary
pins in the lower black ANGLE LOCK sections, the elements always default to 0° when lifted.
Use of the bottom pull-up grid accessory enables the array to be easily compressed with each
element stopping at its pre-selected splay angle. Smaller arrays may be rigidly pinned by lifting
the rear of each element until it hits the pre-selected angle stop, then inserting a second pin
on each side into the appropriate hole in the ANGLE LOCK section. There should be no
fumbling for pin holes because when lifted, the rigging will stop at the pre-selected position.
Electro-Voice
Pull and twist four captive twist lock pins on the top of the lower enclosure.
Four captive twist lock pins are locked in the retracted (open) position.
Repeat for the two front link bars on the bottom of the upper enclosure.
Return the two captive twist-lock pins on the front link bars to the engaged (closed)
position.
Extend and pin the rear link bars.
Guide the link bars of the element or grid above into the V-blocks located at the top
corners of the aluminum rigging.
Twist the four captive twist-lock pins on top of the lower enclosure to return them to the
engaged (closed) position.
Red
Installation manual
Rigging system | en
15
2019-07 | 04 | F.01U.310.953
Advertisement
Table of Contents
