Table of Contents
Advertisement
X-LINE ADVANCE System Rigging & Transport
7.2.2
Assembling an X12-125F-DOK dolly outrigger kit to an X12-125F-DOLLY
Figure 7.3: X12-125F-DOK Dolly Outrigger Kit
Warning!
Ensure the dolly base is level and there is contact to the ground or floor at all four corners.
!
The points of contact must be on a hard surface capable of supporting the weight.
A ground-stacked array that is not solidly supported may topple over, causing property
damage or personal injury.
Caution!
If working on uneven ground, we recommend that two people install the X12-125F-DOK. One
!
person should be in control of the loaded dolly while the other person installs the X12-125-
DOK.
A loaded dolly rolling out of control could cause property damage or personal injury.
Notice!
i
Use X12-125F-DOK outriggers in pairs on the front or back side of dolly ONLY.
Two X12-125F-DOK outrigger kits (four outriggers) may be installed on the same X12-125F-
DOLLY for added stability or leveling.
For maximum acoustical performance and to ensure safety, design your ground stacked array
using Electro-Voice line array configuration software. Consult Electro-Voice line array
configuration software to determine if outriggers are needed and whether the outriggers need
to be added to the front or back of the dolly. Always use both outrigger assemblies on the
same side (front or back) of the X12-125F-DOLLY.
To assemble an X12-125F-DOK outrigger kit to an X12-125F-DOLLY, do the following:
1.
Electro-Voice
Determine if you need to install the X12-125F-DOLLY outrigger kit to the front or back
side of the X12-125F-DOLLY.
Installation manual
Transportation dollies | en
2019-07 | 04 | F.01U.310.953
29
Advertisement
Table of Contents
