Single Pin And Double Pin - Electro-Voice X-LINE ADVANCE Series Installation Manual

X-LINE ADVANCE System Rigging & Transport
3.
–
–
–
–
4.
–
–
–
–
6.3.1

Single pin and double pin

Single pin compression method is used when a pull-up to the grid is employed to pull the rear
rigging together into compression. Double pin is used to set the rear rigging at fixed angles.
Make sure both sides of the element are pinned identically.
Notice!
i
In this section, the rigging steps illustrated with X1/X2 full-range drawings are performed the
same way for the X12-125F subwoofer. Rigging differences between the X1/X2 full-range
elements and the X12-125F subwoofer are noted in the steps, when applicable.
To single pin or double pin, do the following:
1.
Electro-Voice
ANGLE SELECT (in the white section) is used to set the desired splay angle from the
report in the line array configuration software. This is used for both fixed-pin angles and
rear-rigging compression pull-up.
X1 or X2 full-range available angles are: 0.5, 1°, 1.5, 2°, 3°, 4°, 5°, 6°, 8°, and 10°. For a 0°
angle, use the 0° angle hole in the Angle Lock section.
X12-125F available angles are: 1°, 2°, 3°, 4°, 5°, 6°, 8°, CARDIOID and 10°. For a 0º
angle, use the 0º angle hole in the Angle Lock section.
DOLLY WHEEL (the 4º hole) is used to secure the bottom element of a stack to a dolly.
CARDIOID angle selection is only used when a cardioid subwoofer block is being
suspended or ground stacked (X12-125F only).
ANGLE LOCK is used to lock the rear link bar for fixed-pinned angles. Except for a 0°
angle, this section is not used for rear-rigging compression pull up.
0.5° and 1.5° are used to lock those two angles. (X1 or X2 full-range only)
ODD° is used to lock the odd number angles. (X1 or X2 full-range only)
ODD/CARDIOID is used to lock the odd number angles or the angles for a cardioid
subwoofer block. (X12-125F only)
0° EVEN° is used to lock the even number angles and the 0° angle.
Release the quick-release pin from RETRACT LOCK hole.
This step applies to the full-range X1/X2 loudspeakers.
OR
Release the quick-release pin from 0° EVEN hole.
This step applies to the X12-125F subwoofer.
Installation manual
Rigging system | en 17
2019-07 | 04 | F.01U.310.953