Table of Contents
Advertisement
X-LINE ADVANCE System Rigging & Transport
5.
6.
Refer to
–
–
9.2.3
Storing empty dollies
When storing empty dollies, up to five dollies can be stored in the floor space of one.
Notice!
When storing multiple dollies of X12T-DOLLY, X12-125F-DOLLY and X12-128-DOLLY they may
be stacked on top of each other. When stacking mixed dolly models in a single stack it is
i
recommended to place all of the X12-125F-DOLLY dollies on the bottom. The X12T-DOLLY,
and X12-128-DOLLY may be stacked in any order. Use ratchet straps to tie the entire stack of
transport dollies together.
Unsecured dollies may roll off each other if the bottom dolly stops abruptly on an obstruction
like the bottom of a ramp.
X12T-DOLLY:
To store an X12T-DOLLY, do the following:
1.
2.
3.
4.
X12-128-DOLLY:
To store a single X12-128-DOLLY, do the following:
1.
2.
Electro-Voice
Lift the array to the desired height.
Adjust the top grid hoist and bottom pull-back hoist to tilt the array to the angle
recommended by Electro-Voice line array configuration software.
X12TC-GRID compact grid, page 40
Lifting and flying arrays directly from a dolly, page 55
Pull the four ball detent pins from the four corners of the dolly base.
Place the two dolly side panels on top of each other with their carpeted sides together on
the dolly base between the transport rails.
Pick up the top cover with link bars pointing down and set it squarely onto the dolly base
so as to nest the four link bars into the V-blocks on each corner.
Insert an attached dolly detent pin into each corner V-block to lock the two parts
together.
Ensure the ball detent pin goes through the rigging bar and the other side of the
transport rail.
Place the top dolly cover into the dolly base with the wheel pockets are facing up.
Secure with a ratchet strap.
Ensure there is enough clearance between the wheels that the ratchet mechanism does
not interfere with stacking.
Installation manual
Flying the system | en
59
2019-07 | 04 | F.01U.310.953
Advertisement
Table of Contents
