Daily inspection
Warning: For safety reasons, be sure to turn OFF the power to
each piece of equipment before performing the following.
Otherwise, an electric shock may result.
Cable
1. Ensure that cables are not damaged and cable jackets are not torn.
2. Ensure that the power cord plugs are securely connected to both the
equipment AC inlet and the AC outlet.
Detector
1. Ensure that there are no loose screws or breaks.
2. Ensure that there is no dust or foreign matter on the battery bay
connector.
3. Ensure that there are no breaks or short-circuits in the battery bay
connector.
After turning on the power
Start the NX workstation before performing a test exposure.
DX-D 40C, DX-D 40G | Introduction to the DR Detector | 41
0290A EN 20140626 1622