15
Additional information
Problem
Can't operate the remote
control.
Feedback noise when mic is
switched on.
DVD/CD/Video CD player
Problem
The disc is ejected automatically
after loading.
Playback is not possible.
Picture playback stops and the
operation buttons cannot be
used.
Settings are canceled.
No picture/No color.
Screen is stretched or aspect does
not change.
When recorded on a VCR or
passed through an AV selector,
there is disturbance in the
playback picture.
86
En
Remedy
• Replace the batteries (page 7).
• Operate within 23 feet ( 7 m), 30° of the remote sensor on the
front panel (page 8).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct
light.
• The mic is pointing toward the speakers. Keep the mic pointed
away from the speakers.
• The microphone level is set too high. Turn down the mic
control level.
Remedy
• Clean the disc.
• Align the disc properly in the disc guide.
• If the region number on a DVD-video disc does not match the
number on the player, the disc cannot be used (page 10).
• Allow time for any condensation inside the player to evapo-
rate. Avoid using the player near an air-conditioning unit.
• Disc is loaded upside down. Reload the disc with the label side
face up.
• Press 7, then start playback again (3).
• Switch the power off once, then on again using the front panel
STANDBY/ON button.
• When the power is cut due to power failure or by unplugging
the power cord (see Moving the unit, page 84), settings will be
canceled.
• Check that connections are correct and that plugs are inserted
fully.
• Check the instruction manual of the TV/monitor to make sure
the TV/monitor settings are incorrect.
• The TV Screen setting is incorrect. Set the TV Screen option to
match the TV/monitor you're using (page 74).
• Due to the player's copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.