Setting Up The Remote To Control Your Tv; Switching Off The Demo - Pioneer XV-EV51 Operating Instructions Manual

Getting Started
Setting up the remote to
control your TV
You can set up the supplied remote to
control your TV. Here's how to set it up.
1 Switch on your TV.
2 Find the name of the manufacturer of
your TV in the Preset Code List on pages
90–91.
Next to each manufacturer is one or more
three digit codes. These tell the remote what
kind of TV you have.
If the name of the manufacturer of your TV
does not appear in the table, you won't be
able to set up this remote to control your TV.
Note that there are also cases where the
preset codes listed for a manufacturer in the
table may not work for your TV.
3 Point the remote at your TV, hold
down the CLEAR button, then enter the
three digit code for your TV.
The remote transmits an on/off signal to the
TV. If you've entered the correct code, your TV
should switch off.
If your TV doesn't turn off, repeat the
procedure using the next code in the list
until your TV switches off successfully. Once
set, you can then use the individual TV
controls shown below.
Button What it does
Switches your TV on or into
standby.
CHANNEL +/– Changes the TV channel.
VOLUME +/– Adjusts the volume.
INPUT SELECT Switches the TV's input
between the built in TV tuner
and an external video source.

Switching off the demo

This unit has an automatic demo feature
that, when switched on, starts when the unit
is plugged in. Here's how to turn it off:
1 Switch the system on.
2 Press DOLBY NR (DEMO) for about
three seconds to switch the demo mode
off.
• If the demo mode has previously been
switched off, you can switch it on by
switching the system into standby in
step 1, then following step 2.
04
27
En