Pioneer XV-EV51 Operating Instructions Manual page 3

NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/
TV technician for help.
Information to User
Alteration or modifications carried out without
appropriate authorization may invalidate the
user's right to operate the equipment.
CAUTION:
This product satisfies FCC regulations when
shielded cables and connectors are used to
connect the unit to other equipment. To
prevent electromagnetic interference with
electric appliances such as radios and
televisions, use shielded cables and connec-
tors for connections.
CAUTION
• Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiation exposure.
• The use of optical instruments with this
product will increase eye hazard.
CAUTION:
THE STANDBY/ON BUTTON IS
SECONDARY CONNECTED AND THEREFORE
DOES NOT SEPARATE THE UNIT FROM MAINS
POWER IN STANDBY POSITION. therefore install
the unit suitable places easy to disconnect the
MAINS plug in case of the accident. The MAINS
plug of unit should be unplugged from the wall
socket when left unused for a long period of
time.
VENTILATION:
unit, make sure to leave space around the
unit for ventilation to improve heat
radiation (at least 30 cm at top, 15 cm at
rear, and 15 cm at each side).
WARNING:
cabinet are provided for ventilation and to
ensure reliable operation of the product
and to protect it from overheating, to
prevent fire hazard, the openings should
never be blocked and covered with items,
such as newspapers, table-cloths, curtains,
etc. Also do not put the apparatus on the
thick carpet, bed, sofa, or fabric having a
thick pile.
Energy-saving design
This system is designed to use 1W of
electricity when power is switched to Standby.
H010_En
H011_En
VOLTAGE SELECTOR SWITCH
The line voltage selector switch is located on
the rear panel. Check that it is set properly
before plugging the power cord into the outlet.
If the voltage is not properly set, or if you move
to an area where the voltage requirements
H012_En
differ, adjust the selector switch as follows:
1. Make sure the power cord is disconnected.
2. Insert a small-sized screwdriver into the
groove on the voltage selector, and adjust
the VOLTAGE SELECTOR.
H013_En
Power source voltage is factory
adjusted at 220-230 volts. If your area is
different, change the voltage selector's
setting.
H017B_En
When installing this
Slot and openings in the
CAUTION 220-230 V
H039En
H040 En
3
En