Controlling The Rest Of Your System; Setting The Remote To Control Other; Select Preset Codes For Tvs - Pioneer HTP-SB300 Operating Instructions Manual

Controlling the rest of your system

Chapter 5
Controlling the rest of your
system
Setting the remote to control
other components
Most components can be assigned to one of
the or
INPUT SELECT
the component's manufacturer preset code
stored in the remote.
However, please note that there are cases
where only certain functions may be
controllable after assigning the proper preset
code, or the codes for the manufacturer in the
remote control will not work for the model that
you are using.
Note
• You can cancel or exit any of the steps by
pressing
• After one minute of inactivity, the remote
automatically exits the operation.
buttons using
.

Select preset codes for TVs

SYSTEM
SYSTEM
INPUT SOURCE
INPUT TV CONTROL
HDMI1 HDMI2
CH
OPTICAL COAXIAL INPUT
TV CODE
STANDARD ADV SURR
AUTO/ STEREO/
VOL
1 While pressing the
press and hold the '
1
seconds.
2 Press the
3 Use the number buttons to enter the
preset code.
You can find the preset codes on page 31.
If the correct code has been input the power of
the TV being input will turn on or off.
The power of the TV being input will only turn
on or off if that TV is able to be turned on
directly by remote control.
4 Repeat steps 2 through 3 to try a different
code.
5 When you're done, press
ANT
MUTE
DISPLAY
CH
CH
ENTER
button,
' button for three
button.
.
05
27
En