Away; Feels Like - Lennox iComfort S30 User Manual

If you do not wish to create your account using the Creating a New Account
screen, then you will need to select the Generate Pin option and write down
the pin number that appears on the screen. The pin number will be used to
associate your system to your user account. First, create your account using
either the iComfort Thermostat App or consumer website. The first time you
login to your account the screen will indicate no iComfort detected. Press on
the thermostat image, enter your pin number, and press add. If you enter the
number incorrectly the screen will indicate the number entered is invalid. Retry
again. When successful, the setup will continue on to the next applicable
screen. If you are adding an additional system to your account, press on the
menu and select add iComfort.
NOTE - The generate pin option is not required if the account is setup from the
thermostat or this is a new additional system, login to the account from the new
thermostat.
There is also a selection option after the account is setup and active which is
called move out. Using this feature just like the remove home feature, will
remove the system/home address information from the consumer portal
account or mobile application. This will only remove the system that is currently
active. Your account is still valid.

AWAY

Away (Smart Away) is a feature that can be enabled once you have created
and registered your account. Both Home Info and Account menu options must
be completed before this option can be enabled. Once enabled, you can set the
low and high temperature settings when smart away determines that no one is
home. The Smart Away feature depends on the iComfort Thermostat App
running on your mobile device (smart phone or tablet).
NOTE - When Away is selected on the home screen, Smart Away is disabled
until Away is canceled from the home screen.
Smart Away can also be enabled from your mobile device, once you have
installed the Lennox iComfort Thermostat App and logged in. Go to the menu
> settings > away and turn ON smart away. To allow the mobile device you
are on to use this feature, turn ON participate. The away fence option will
appear and by default, the setting is for one mile. The range for this setting is
1/4 to 4 miles.
It is also recommended to enable location services on your mobile device to
enhance the location accuracy when traveling away from home. Consult your
mobile device user guide for instructions.
Generate Pin
Move Out
55°
smart away
Use the iComfort app to control the temperatures in your home while you are away
reset smart away
Turn participate off in all mobile devices (there are currently 2 mobile devices participating)
away set−points
55°
min
Please make sure to install the iComfort S30 mobile App to participate in Smart Away.
You can also configure the away fence in the mobile App.
There are currently 2 mobile devices participating.
Figure 8. Smart Away Screen

FEELS LIKE™

The feels like feature uses a combination of outdoor temperature and indoor
humidity to come up with the feels like comfort level in the home.
NOTE - Feels Like is not a temperature setting but the temperature that the
space feels like based on current outdoor temperature and indoor humidity. To
adjust Feels Like, lower indoor temperature, or both indoor temperature and
humidity percentage settings.
feels like
Display and control your system using feels like temperatures instead of actual temperatures
outdoor indoor
temperature temperature
+
Feels like temperatures factor in the outdoor temperature
and indoor humidity for more accurate control of the temperatures in your home
Figure 9. Feels Like™ Screen
10
away
85°
feels like
indoor
feels like
humidity
+
= 75°
on
on