Routing Information Protocol; Rip Configuration - NETGEAR ProSafe GSM7328 Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide
Set the OSPF priority and cost for the VLAN and physical router ports.
(Netgear Switch) (Config)#interface vlan 10
(Netgear Switch) (Interface vlan 10)#ip ospf priority 128
(Netgear Switch) (Interface vlan 10)#ip ospf cost 32
(Netgear Switch) (Interface vlan 10)#exit
(Netgear Switch) (Config)#interface vlan 20
(Netgear Switch) (Interface vlan 20)#ip ospf priority 255
(Netgear Switch) (Interface vlan 20)#ip ospf cost 64
(Netgear Switch) (Interface vlan 20)#exit
(Netgear Switch) (Config)#exit

Routing Information Protocol

Routing Information Protocol (RIP) is one of the protocols which may be used by routers to
exchange network topology information. It is characterized as an "interior" gateway protocol, and
is typically used in small to medium-sized networks.

RIP Configuration

A router running RIP will send the contents of its routing table to each of its adjacent routers every
30 seconds. When a route is removed from the routing table it will be flagged as unusable by the
receiving routers after 180 seconds, and removed from their tables after an additional 120 seconds.
There are two versions of RIP:
• RIPv1 defined in RFC 1058
– Routes are specified by IP destination network and hop count
– The routing table is broadcast to all stations on the attached network
• RIPv2 defined in RFC 1723
– Route specification is extended to include subnet mask and gateway
– The routing table is sent to a multicast address, reducing network traffic
– An authentication method is used for security
The 7000 Series Managed Switch supports both versions of RIP. You may configure a given port:
• To receive packets in either or both formats
• To transmit packets formatted for RIPv1 or RIPv2 or to send RIPv2 packets to the RIPv1
broadcast address
• To prevent any RIP packets from being received
5-12
v1.1, May 2006
IP Routing Services