NETGEAR ProSafe GSM7328 Administration Manual page 22

NETGEAR 7000 Series Managed Switch Administration Guide
Table 1-1. Quick Start Commands
Command
copy system:run-
ning-config
nvram:startup-
config
logout
show network
network parms
<ipaddr> <net-
mask> [gateway]
copy nvram:star-
tup-config
<tftp://<ipad-
dress>/<file-
path>/<filename>>
1-8
Mode
Privileged Saves passwords and all other changes to the device.
EXEC
If you do not save the configuration, all changes are lost when
you power down or reset the networking device. In a stacking
environment, the running configuration is saved in all units of
the stack.
User EXEC Logs the user out of the networking device.
Privileged
EXEC
User EXEC Displays the following network configuration information:
• IP Address - IP Address of the interface (default: 0.0.0.0)
• Subnet Mask - IP Subnet Mask for the interface (default:
0.0.0.0)
• Default Gateway - The default Gateway for this interface
(default: 0.0.0.0)
• Burned in MAC Address - The Burned in MAC Address used
for in-band connectivity
• Locally Administered MAC Address - Can be configured to
allow a locally administered MAC address
• MAC Address Type - Specifies which MAC address should
be used for in-band connectivity
• Network Configurations Protocol Current - Indicates which
network protocol is being used (default: none)
• Management VLAN Id - Specifies VLAN id
• Web Mode - Indicates whether HTTP/Web is enabled.
• Java Mode - Indicates whether java mode is enabled.
Privileged Sets the IP address, subnet mask and gateway of the router. The
EXEC IP address and the gateway must be on the same subnet. IP
address range is from 0.0.0.0 to 255.255.255.255.
Privileged Starts the configuration file upload, displays the mode and type
EXEC of upload and confirms the upload is progressing.
The URL must be specified as:
xmodem:<filepath>/<filename>
For example:
If the user is using HyperTerminal, the user must specify where
the file is going to be received by the PC.
v1.1, May 2006
Description
Getting Started