Example #2: Enable Routing For Ports; Example #3. Enable Rip For The Switch - NETGEAR ProSafe GSM7328 Administration Manual
Managed switch
Hide thumbs
Also See for ProSafe GSM7328:
- Installation manual (2 pages) ,
- Brochure (2 pages) ,
- Application note (16 pages)
Table of Contents
Advertisement
NETGEAR 7000 Series Managed Switch Administration Guide
Example #2: Enable Routing for Ports
The following command sequence enables routing and assigns IP addresses for ports 1/0/2 and 1/
0/3.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#exit
Example #3. Enable RIP for the Switch
The next sequence enables RIP for the switch. the route preference defaults to 15.
(Netgear Switch) #config
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#exit
(Netgear Switch) (Config)#exit
5-14
v1.1, May 2006
IP Routing Services
Hide quick links:
Advertisement
Table of Contents
