Cli Examples; Example 1. Enabling Routing For The Switch - NETGEAR ProSafe GSM7328 Administration Manual
Managed switch
Hide thumbs
Also See for ProSafe GSM7328:
- Installation manual (2 pages) ,
- Brochure (2 pages) ,
- Application note (16 pages)
Table of Contents
Advertisement
CLI Examples
This diagram shows a Layer 3 switch configured for port routing. It connects three different
subnets, each connected to a different port. The script shows the commands you would use to
configure a 7000 Series Managed Switch to provide the port routing support shown in the diagram.
Figure 5-1
Example 1. Enabling routing for the Switch
Use the following command to enable routing for the switch. Execution of the command enables
IP forwarding by default.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit
IP Routing Services
NETGEAR 7000 Series Managed Switch Administration Guide
v1.1, May 2006
5-3
Hide quick links:
Advertisement
Table of Contents
