F6: SYSCON Board
IP200
12-2. Flash ROM Software Version Up Procedure
Connect the VTR with personal computer by RS232C cable (Cross cable) as below. No Hardware tool is required
to proceed this version up. (Just software tool is required)
RS-232C cable (Cross cable)
1. Prepare a personal computer (Windows95 or 98)
2. Install the version up software VFK**** into the personal computer.
VFK**** consist of following 4 types of software.
f_servo.obf
FW103u.exe
VSI2312L.exe
Setting ini
IP1300
IP700
(COMPONENT SIDE)
PC
F7: SERVO Board
VTR
Figure A
INF-19
IP201
IP300
(COMPONENT SIDE)
RS-232C Terminal
(Rear Jack)