Distinction Sw Unit Replacement; Reel Drive Motor Unit Replacement - Panasonic DVCPRO50 Service Manual

5-23. Distinction SW Unit
Replacement
(Removal)
1. Disconnect the P17 on the MECH I/F.
2. Remove the MIC Drive Rev Spring at Distinction
Switch Unit side as shown in Figure 5-23-1.
3. Unscrew the 3 screws (A) and remove the MIC
Rail Unit as shown in Figure 5-23-1.
(Installation)
1. Install the new Distinction Switch Unit following
the removal steps in reverse order.
2. Confirm that the M and L cassettes touch to
Distinction Switch Unit correctly.
Figure 5-23-1
(A)
DISTINCTION
SW UNIT
5-24. Reel Drive Motor Unit
Replacement
(Removal)
1. Disconnect the P16 on the MECH I/F.
2. Unscrew the 2 screws (A) and remove the Reel
Drive Sensor P.C.Board as shown in Figure
5-24-1.
3. Unscrew the 2 screws (B) and remove the Reel
Drive Motor Unit as shown in Figure 5-24-1.
(Installation)
1. Install the new Reel Drive Motor Unit following the
removal step in reverse order.
MECH-57
Figure 5-24-1