Electrical Connections; Wireless Antenna Connections - Omron HD-1500 Assembly Instructions Manual

3 Installation
3-4

Electrical Connections

Use the following information to understand the AMR's electrical connections.
3-4-1

Wireless Antenna Connections

Wireless antennas may need to be relocated from the factory installed position to new position if the
payload interferes with the signal.
Precautions for Correct Use
It is the end user's responsibility to ensure that the payload does not attenuate the wireless an-
tennas' signal.
A wireless antenna extension kit is available (part number 68955-000) if wireless antennas need to be
relocated. The kit includes the following items.
• Two low loss extension cables (2 m)
• Two dipole antennas with reverse SMA plug and 90° pivot (137 mm in length)
Additional Information
• Contact your local OMRON representative if longer extension cables or different antennas
are required.
• The AMR Controller provides two connections for wireless antennas. Refer to 1-3 Features
and Components on page 1-6 for more information.
Wireless Antenna Relocation Procedure
Use the following procedure to relocate the wireless antennas. This procedure details the relocation of
one of the antennas and should be repeated if both antennas need to be relocated.
The following items are required for this procedure.
• A wireless antenna extension kit (part number 68955-000).
• 2.5 mm hex key.
• 8 mm wrench or socket driver.
1
Use a 2.5 mm hex key to remove the 4 screws that fasten the wireless antenna cover to the
AMR and then remove the cover.
The cover is not used when the wireless antenna is relocated.
3-8
HD-1500 Platform Assembly Instructions (18407-150)