Table of Contents
Advertisement
Return the router to its factory default
settings
Under some circumstances (for example, if you lost track of the changes that you made
to the router settings or you move the router to a different network), you might want to
erase the current configuration and reset the router to factory default settings.
To reset the router to factory default settings, you can use either the Reset button on
the back of the router or the Erase function.
After you reset the router to factory default settings, the user name is admin, the
password is password, the LAN IP address is 192.168.1.1 (which is the same as
www.routerlogin.net), and the DHCP server is enabled.
Note: If the router is in access point mode and you do not know the IP address that is
assigned to it, first try to use an IP scanner application to detect the IP address. (IP
scanner applications are available online free of charge.) If you can detect the IP address,
you don't need to reset the router to factory default settings.
Use the Reset button
CAUTION:
This process erases all settings that you configured in the router.
To reset the router to factory default settings:
1. On the back of the router, locate the Reset button.
2. Using a straightened paper clip, press and hold the Reset button for at least five
seconds.
3. Release the Reset button.
The Power LED starts blinking. When the reset is complete, the router restarts. This
process takes about two minutes.
WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the reset.
For example, if you are connected to the router web interface, do not close the
browser, click a link, or load a new page. Do not turn off the router. Wait until the
router finishes restarting.
Manage and Monitor Your
Router
4-Stream AX1600 WiFi 6 Router Model RAX5
130
User Manual
Advertisement
Table of Contents
