Crankshaft/Camshaft/Piston; Removal/Installation - Honda HRG416C1 Manual

dummyhead dummyhead

CRANKSHAFT/CAMSHAFT/PISTON

REMOVAL/INSTALLATION

Remove the engine (page 9-2).
Remove the cylinder (page 10-4).
CONNECTING ROD CAP
(Bearing area)
INSTALLATION:
Align the projections [1] of the
cap and connecting rod.
[1]
CONNECTING ROD BOLT (2)
(Threads and seating surface)
12 N·m (1.2 kgf·m, 9 lbf·ft)
TIMING GEAR
(Teeth)
THRUST WASHER
(Both sides)
CRANKSHAFT
(Journal and crankpin)
CRANKSHAFT/PISTON/VALVES
PISTON/CONNECTING ROD
ASSEMBLY
INSTALLATION:
The mark [1] points
toward the flywheel
side [2].
(Piston outer surface and big end bearing area)
(including decompressor)
CAMSHAFT
(Bearing, cam profile, and decompressor)
VALVE LIFTER BOLT (2)
(Shaft journal)
10 N·m (1.0 kgf·m, 7 lbf·ft)
CRANKCASE
OIL SEAL (28 x 41.25 x 6 mm)
(Lips)
[2]
[1]
VALVE LIFTER (2)
(Slipper surface)
(Bearing area)
10-7