Honda HRG416C1 Manual page 45

dummyhead dummyhead
GOVERNOR SYSTEM
GOVERNOR REMOVAL/INSTALLATION
Remove the crankshaft (page 10-7).
GOVERNOR WEIGHT HOLDER
CHECK:
Before installing, check for wear and
damage of the gear.
Check that the weights move freely.
Groove
(Journal)
GOVERNOR HOLDER
SHAFT
6-4
THRUST WASHER
(6 mm)
GOVERNOR HOLDER CLIP
ASSEMBLY:
Insert firmly into the shaft
groove.
BOLT (6 x 14 mm)
12 N·m (1.2 kgf·m, 9 lbf·ft)
CRANKCASE
GOVERNOR SLIDER
ASSEMBLY:
Slide the governor weights to
install the slider; then check to
be sure the slider moves
smoothly.
GOVERNOR WEIGHT (2)
GOVERNOR WEIGHT PIN (2)
LOCK PIN
INSTALLATION:
Install the lock pin [1] immediately after
installing the governor arm shaft [2], and
move the shaft over against the governor
slider.
The lock pin must be installed with the
straight side [3] of the pin against the
groove [4] in the shaft.
(Journal)
GOVERNOR ARM SHAFT
WASHER (6 mm)
[4]
[3]
[1]
[2]