Honda HRG416C1 Manual page 43

dummyhead dummyhead
GOVERNOR SYSTEM
GOVERNOR ARM
GOVERNOR SYSTEM
REMOVAL/INSTALLATION
Remove the carburetor (page 5-6).
After installation, adjust the governor (page 6-3).
GOVERNOR ROD/
THROTTLE RETURN SPRING
INSTALLATION:
Install the governor rod through
the throttle return spring as shown.
FUEL TUBE (110 mm)
TUBE CLIP B8
INSTALLATION:
Be sure it is installed in
position and direction
properly (page 2-5).
FUEL VALVE
TUBE CLIP B12
INSTALLATION:
Be sure it is installed in
position and direction
properly (page 2-5).
FUEL TUBE (160 mm)
CT BOLT (6 x 14 mm)
6-2
PAINT MARK
(Governor side)
GOVERNOR
ARM BOLT
SCREW (5 x 12 mm)
2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
FUEL VALVE STAY
NUT (6 mm)
GOVERNOR ARM
GOVERNOR SPRING