dummyhead
dummyhead
ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL/INSTALLATION
Remove the following:
– Starter grip from the handlebar.
– Blade holder (base shop manual 62VH300 page 14-5)
– Drive belt (If equipped) (base shop manual 62VH300 page 14-5)
• Route the cable properly (page 2-5).
FLYWHEEL BRAKE CABLE
REMOVAL/INSTALLATION:
ENGINE
9-2
SCROLL GUIDE
(With drive clutch system)
COLLAR WASHER (4)
(With drive clutch system)
ENGINE SETTING BOLT (4)
DRIVE PULLEY
INSTALLATION:
Install the drive pulley [1] onto the drive belt [2],
and onto the crankshaft by aligning the groove
[3] with the key [4].
[2]
[1]
WOODRUFF KEY
[4]
[3]