When the following window appears, click [Yes].
6.
Next, set parameters to automatically perform data transfer between link devices of the servo amplifiers and devices of
the programmable controller. Double-click "Detailed Setting" of "Refresh Settings".
7.
Select "Specify Device" for the refresh targets on the CPU module side, and set the names and start addresses of the
devices to be assigned to the link devices. After the setting, click [Apply]. In this manual, the following setting values are
used.
Device name of the link side
RX
RY
RWr
RWw
3 PROGRAMMABLE CONTROLLER SETTINGS
27
3.5 Parameter Settings
Target
Specify Device
Specify Device
Specify Device
Specify Device
Double-click
Device Name
B
B
W
W
Start
00000
00080
00000
00040