Installing The The Sample Configuration; Installing The Et 200Isp; Installing The S7-400; Installing Rj45/Foc Media Converter Or Rs 485-Is Coupler - Siemens SIMATIC ET 200iSP Operating Instructions Manual

Commissioning guideline

3.5 Installing the the Sample Configuration

3.5 Installing the the Sample Configuration
3.5.1

Installing the ET 200iSP

Installing the ET 200iSP
1. Install the mounting rail (480 mm) into the enclosure which has been mounted on a solid
base.
2. Install the modules starting at the left-hand end of the DIN rail. Start with the terminal
module TM-PS-A (hook in - swivel in - 2 x screw on). Continue with the remaining modules
(fit onto top of rail - push in at the bottom - push to the left). Insert the modules in the
following order:
– Terminal module TM-PS-A
– Terminal module TM-IM/EM
– Terminal module TM-EM/EM
– Terminating module
3.5.2

Installing the S7-400

Installing the S7-400
1. Install the rack on a stable surface. See operating instructions Automation System S7-400:
Hardware and Installation
1117849)
2. On the left of the rack, start by installing the separate modules (hang in - swivel into position
- screw on tightly). Insert the modules in the following order:
– Power supply module PS
– Central processing unit CPU
3.5.3

Installing RJ45/FOC media converter or RS 485-IS coupler

The installation of the component depends on the selected configuration:
• With a PROFINET system, you need to connect the IM 152-1PN to a PROFINET IO via a fiber-
optic cable and a media converter (e.g. RJ45/FOC) with an intrinsically safe output.
• With a PROFIBUS system, you need to connect the IM 152-1DP to PROFIBUS DP via an
intrinsically safe PROFIBUS RS 485-IS and an RS 485-IS coupler.
42
(https://support.automation.siemens.com/WW/view/en/
Operating Instructions, 11/2022, A5E00247483-AK
ET 200iSP