Diagnostics With Step 7 With Profinet; Reading The Diagnostics For Profinet; Diagnostic Messages Of The Electronic Modules With Profinet - Siemens SIMATIC ET 200iSP Operating Instructions Manual

7.12

Diagnostics with STEP 7 with PROFINET

7.12.1

Reading the diagnostics for PROFINET

PROFINET uses the standard diagnostics. See System software for S7-300/400 System and
standard functions (https://support.automation.siemens.com/WW/view/en/1214574).
7.12.2

Diagnostic messages of the electronic modules with PROFINET

Introduction
You can set parameters for the diagnostic messages of the following modules:
• Digital input modules
• Digital output modules
• Analog input modules
• Analog output modules
Digital input modules
Table 7-10
Diagnostic message
Short-circuit
Wire break
Error
External fault
Digital output modules
Table 7-11
Diagnostic message
Short-circuit
Wire break
Error
Actuator disconnection
Enabling the actuator disconnection by means of the group diagnostics parameter
1
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK
Digital input modules
Digital output modules
Commissioning and Diagnostics
7.12 Diagnostics with STEP 7 with PROFINET
Applicability
Channel
Channel
Module
Channel
Applicability
Channel
Channel
Module
Channel
Can be set
Yes
Yes
No
No
Can be set
Yes
Yes
No
Yes
1
189