Coolant Replacement - APRILIA SCARABEO 125 Service Manual

SCARABEO 125 - 200
C
Specification
below 90º (194º)
Above 90º (194º)

Coolant replacement

Emptying
NOTE
USE A CONTAINER OF ADEQUATE CAPACITY TO COLLECT THE FLUID THAT MAY LEAK DUR-
ING OPERATION.
•
Remove the legshield.
•
Loosen the clamp.
•
Slide off the pipe.
•
Drain off the system.
NOTE
REMOVE THE EXPANSION TANK CAP TO FACILITATE
COOLANT DRAINAGE.
WARNING
SHOULD THE CIRCUIT BE FULLY EMPTIED, LIFT THE
FRONT WHEEL AT LEAST 55 cm (21.65 in) FROM THE
GROUND.
Filling
•
Reposition the coolant delivery pipe
and tighten with a clamp.
•
Top-up the expansion tank with cool-
ant until the fluid level reaches the
"MAX" reference mark.
•
Top-up the radiator with coolant until it
is full and close the snap-on cover.
•
Set the vehicle into motion and let the
engine idle until the fan switches on.
•
Shut off the engine and let it cool down
for 12 hours.
•
Check the level at both the expansion
tank and the radiator; fill up to the cor-
rect level if required.
•
Refit the front shield.
Locking torques (N*m)
Coolant piping clamp retainers
C (
OOLANT TEMPERATURE º
3 (2.22 lbf ft)
F) / R
º ESISTANCE VALUES
Desc./Quantity
Cooling system
(O )
HM
Infinite
0
COOL SYS - 175